Registration Number
0210U007909,
0109U007825
, R & D reports
Title
Development of a multichannel elektronic recorder of impulsesignals
popup.stage_title
Head
Shapovalov Valentin,
Registration Date
04-01-2011
Organization
Scientific Research and Design Institute "Iskra"
popup.description2
The basis for the creation of a block of the electronic recorder was an existing device. Its power module and case were used. Instead of the light-emitting-diode field a liquid-crystal display was used to display the information in a configuration mode about a type of the conveyer, a place of its installation, its width and the length of the belt, a belt speed, a packing wire pattern in the abutting joint, a configuration of the borders in the abutting joint, a number of wires in the belt, a number of abutting joints in the belt, performed by a similar packing pattern, a number of control channels, a correction coefficient, a maximum permissible value of the ratio of the arithmetic mean value of amplitudes of negative and positive phases of the information signal, a single-level access password. In the automatic mode the display shows the information about the distance between a hazardous damage and the last abutting joint passed through the control zone of a sensing device, a coefficient of damaged wires, the number of the channel where the damaged wires of the belt were detected. The electronic recorder provides shutdown of the conveyer through a control relay if an accidental breakage of wires happens, and accepts the information from the four-keys keyboard. s, number of channel in which found out the damages of rope tape base. An electronic recorder provides disconnecting of conveyer at the emergency precipice of ropes through an executive relay and carries out the reception of information from four button keyboard
Product Description
popup.authors
Воропай Микола Володимирович
Калюжний Андрій Валерійович
Кочергін Олександр Васильович
Мороз Микола Георгійович
popup.nrat_date
2020-04-02
