Пошук академічних текстів

Інформація × Реєстраційний номер 2123U002989, Матеріали видань та локальних репозитаріїв Категорія Бакалаврська робота Назва роботи Manufacturing Process Planning for the Part "Support" Автор Alabaidat Ahmed Mahdi Abdulla Ebrahim Ali Дата публікації 01-01-2023 Постачальник інформації Національний технічний університет України «Київський політехнічний інститут імені Ігоря Сікорського» Першоджерело https://ela.kpi.ua/handle/123456789/62134 Видання Kyiv Опис The bachelor's thesis on the topic "Process Planning for Manufacturing of the «Support» part. It consists of 61 sheets of A4 format and contains 59 illustrations, and 5 tables. The objective of this thesis is the development of the manufacturing process for the "Support" part. In the first chapter, a simulation of the casting process was performed. In the second chapter, the sequence of manufacturing operation was developed. Within this task CNC machines, cutting tools, and cutting conditions were selected. For the two specific manufacturing operations the fixtures were selected, and corresponding setups were developed. Economic calculations were performed for the first manufacturing operation. The graphic part consists of 6 sheets of Al format, as follows: 1. Cast iron : Simulation 2. Drawings and 3D models of the "Support" part and blank 3. Manufacturing operation presentation 4. Fixture setup for the 1st manufacturing operation 5. Fixture setup for the last manufacturing operation 6. Results of CNC code development Додано в НРАТ 2025-01-29 Закрити